Accueil / Forums / Matériels / Imprimante 3D – BCN3D + / Clogged? Plastic won't feed

Affichage de 1 message (sur 1 au total)
  • kesizewi
    Participant
    Nombre d'articles : 0
    #1936 |

    Hi,

    So I got my printer yesterday evening. Calibrated, leveled, loaded it with filament and was on my way. Once I ran out of filament I never really thought how I should load new filament? Just like the first time, I heated up the nozzle to 230 centigrade, and applied even pressure hopefully it would come out. A very small bit a plastic came out but after than tiny bit, nothing more. Also the new filament I had loaded, you could see that it had not melted. I even tried to trim down the plastic and give it a smaller diameter before putting it through. Still won’t work. I’m not sure what to try, I was using ABS and heard about a method where you take the nozzle and bathe it in Acetone. Good or Bad idea? Necessary?

    Please help.

    I didn’t find the right solution from the Internet.

    References:-
    https://bit.ly/2JfBHJr
    Business video agency

    Thanks

  • Auteur
    Messages
  • #1936

    kesizewi
    Participant
    • Offline

    Hi,

    So I got my printer yesterday evening. Calibrated, leveled, loaded it with filament and was on my way. Once I ran out of filament I never really thought how I should load new filament? Just like the first time, I heated up the nozzle to 230 centigrade, and applied even pressure hopefully it would come out. A very small bit a plastic came out but after than tiny bit, nothing more. Also the new filament I had loaded, you could see that it had not melted. I even tried to trim down the plastic and give it a smaller diameter before putting it through. Still won’t work. I’m not sure what to try, I was using ABS and heard about a method where you take the nozzle and bathe it in Acetone. Good or Bad idea? Necessary?

    Please help.

    I didn’t find the right solution from the Internet.

    References:-
    https://bit.ly/2JfBHJr
    Business video agency

    Thanks

Affichage de 1 message (sur 1 au total)

Vous devez être connecté pour répondre à ce sujet.